Lead-acid starter batteries - Properties of battery housings and handles1 Scope This European Standard covers multicell battery housings produced of polypropylene as the preferred material for lead acid batteries as an energy storage device for cranking combustion engines, for lighting and for additional equipment used in road vehicles. These batteries are all referred to as starter batteries. This European Standard describes battery housings for batteries usable within the engine compartment and for installation under

and standards developers building models for health information management systems

local regulatory requirements

This method is not applicable when acrylic fibres are present

18R (cylindrical plug

the recommendations that might affect product design do not apply

6 Responsibilities

Pneumatic test

and inversely

prevent oil from separating

quick and at reasonable cost

This document also specifies the sampling and conditioning procedures of specimens

material identification