Forge Motorsport Hard Pipe with Single Valve and Kit - E8X | E9X | N54Suitable for the BMW 335 fitted with the N54 Twin Turbo engine. This alloy hard pipe fits to the throttle body and incorporates our high flow Blow off valve. This new valve fresh from our R&D department is the largest displacement valve that Forge have ever made! Featuring a 50mm (2") aluminium piston so that there are no issues with split diaphragms, we have not found the power handling limits of this valve yet! The piston uses heat stabilised viton

Audi - A4 Allroad 2009-2015 (B8/B8

one-piece design

and substantial cooling benefits over the factory setup

Cassettes have improved primary connector for greater ease of assembly compared to designs with one connector for each coil

Esso LT 71141

The Mk7 Golf R and Audi 8V S3 use a bigger turbo than the GTI and A3

the Track Edition Exhaust

RIFLE DRILLING: Also referred to as Forced Pin Oiling (FPO)

Inside Diameter: 60mm ID Length: 200mm Spring Rate: 140 N/mm or 800 lbs/inch

RPM Limiter Increased to 6700

While Not required we HIGHLY recommend them

On 100 octane fuel